Dispersion strengthening in vanadium microalloyed steels processed by simulated thin slab casting and direct charging: Part I - Processing parameters, mechanical properties and microstructure

A study simulating thin slab continuous casting followed by direct charging into an equalisation furnace has been undertaken based on six low carbon (0.06wt-%) vanadium microalloyed steels. Mechanical and impact test data showed properties were similar or better than those obtained from similar microalloyed conventional thick cast as rolled slabs. The dispersion plus dislocation strengthening was estimated to be in the range 80-250MPa.A detailed TEM/EELS analysis of the dispersion sized sub-15nm particles showed that in all the steels, they were essentially nitrides with little crystalline carbon detected. In the Steels V-Nb, V-Ti and V-Nb-Ti, mixed transition metal nitrides were present. Modelling of equilibrium precipitates in these steels, based on a modified version of ChemSage, predicted that only vanadium rich nitrides would precipitate in austenite but that the C/N ratio would increase through the two phase field and in ferrite. The experimental analytical data clearly points to the thin slab direct charging process, which has substantially higher cooling rates than conventional casting, nucleating non-equilibrium particles in ferrite which are close to stoichiometric nitrides. These did not coarsen during the final stages of processing, but retained their highly stable average size of ~7nm resulting in substantial dispersion strengthening. The results are considered in conjunction with pertinent published literature

Evolution of precipitates, in particular cruciform and cuboid particles, during simulated direct charging of thin slab cast vanadium microalloyed steels

A study has been undertaken of four vanadium based steels which have been processed by a simulated direct charging route using processing parameters typical of thin slab casting, where the cast product has a thickness of 50 to 80mm ( in this study 50 mm) and is fed directly to a furnace to equalise the microstructure prior to rolling. In the direct charging process, cooling rates are faster, equalisation times shorter and the amount of deformation introduced during rolling less than in conventional practice. Samples in this study were quenched after casting, after equalisation, after 4th rolling pass and after coiling, to follow the evolution of microstructure. The mechanical and toughness properties and the microstructural features might be expected to differ from equivalent steels, which have undergone conventional processing. The four low carbon steels (~0.06wt%) which were studied contained 0.1wt%V (V-N), 0.1wt%V and 0.010wt%Ti (V-Ti), 0.1wt%V and 0.03wt%Nb (V-Nb), and 0.1wt%V, 0.03wt%Nb and 0.007wt%Ti (V-Nb-Ti). Steels V-N and V-Ti contained around 0.02wt% N, while the other two contained about 0.01wt%N. The as-cast steels were heated at three equalising temperatures of 1050C, 1100C or 1200C and held for 30-60 minutes prior to rolling. Optical microscopy and analytical electron microscopy, including parallel electron energy loss spectroscopy (PEELS), were used to characterise the precipitates. In the as-cast condition, dendrites and plates were found. Cuboid particles were seen at this stage in Steel V-Ti, but they appeared only in the other steels after equalization. In addition, in the final product of all the steels, fine particles were seen, but it was only in the two titanium steels that cruciform precipitates were present. PEELS analysis showed that the dendrites, plates, cuboids, cruciforms and fine precipitates were essentially nitrides. The two Ti steels had better toughness than the other steels but inferior lower yield stress values. This was thought to be, in part, due to the formation of cruciform precipitates in austenite, thereby removing nitrogen and the microalloying elements which would have been expected to precipitate in ferrite as dispersion hardening particles

Gender-specific association of the K121Q Ectonucleotide Pyrophosphatase Phosphodiesterase (ENPP) 1 polymorphism with subcutaneous adiposity in a South African Black population

Purpose: This study aimed to determine whether the ENPP-1 K121Q (rs1044498) polymorphism was associated with adiposity and cardiometabolic disease markers within a South African Black population. Methods: Black participants from the greater Johannesburg–Soweto area in South Africa, for whom metabolic syndrome status, cardiometabolic disease markers, adipokine levels and body fat distribution had already been measured, were genotyped by PCR-RFLP for the presence of the K121Q polymorphism.Results: Within a cohort of 345 Black South Africans, the frequency of the ENPP-1 K121Q C allele was 0.89. In the total cohort, the K121Q polymorphism was not significantly associated with any cardiometabolic disease markers or adipokine levels. However, in the female population the CC genotype was shown to be associated with increased abdominal subcutaneous fat levels (p=0.007). Conclusion: This cohort of Black South Africans had a higher frequency of the C allele when compared to reported data for Asian and Caucasian populations, however this frequency was comparable to other African data. The presence of the rs1044498 polymorphism was not associated with markers of cardiometabolic disease, suggesting that these associations may be population dependent. The gender-specific genotypic association with subcutaneous fat levels is a novel finding requiring further investigation

The position of graptolites within Lower Palaeozoic planktic ecosystems.

An integrated approach has been used to assess the palaeoecology of graptolites both as a discrete group and also as a part of the biota present within Ordovician and Silurian planktic realms. Study of the functional morphology of graptolites and comparisons with recent ecological analogues demonstrates that graptolites most probably filled a variety of niches as primary consumers, with modes of life related to the colony morphotype. Graptolite coloniality was extremely ordered, lacking any close morphological analogues in Recent faunas. To obtain maximum functional efficiency, graptolites would have needed varying degrees of coordinated automobility. A change in lifestyle related to ontogenetic changes was prevalent within many graptolite groups. Differing lifestyle was reflected by differing reproductive strategies, with synrhabdosomes most likely being a method for rapid asexual reproduction. Direct evidence in the form of graptolithophage 'coprolitic' bodies, as well as indirect evidence in the form of probable defensive adaptations, indicate that graptolites comprised a food item for a variety of predators. Graptolites were also hosts to a variety of parasitic organisms and provided an important nutrient source for scavenging organisms

The cost-effectiveness of providing antenatal lifestyle advice for women who are overweight or obese: the LIMIT randomised trial

BACKGROUND: Overweight and obesity during pregnancy is common, although robust evidence about the economic implications of providing an antenatal dietary and lifestyle intervention for women who are overweight or obese is lacking. We conducted a health economic evaluation in parallel with the LIMIT randomised trial. Women with a singleton pregnancy, between 10(+0)-20(+0) weeks, and BMI ≥25 kg/m(2) were randomised to Lifestyle Advice (a comprehensive antenatal dietary and lifestyle intervention) or Standard Care. The economic evaluation took the perspective of the health care system and its patients, and compared costs encountered from the additional use of resources from time of randomisation until six weeks postpartum. Increments in health outcomes for both the woman and infant were considered in the cost-effectiveness analysis. Mean costs and effects in the treatment groups allocated at randomisation were compared, and incremental cost effectiveness ratios (ICERs) and confidence intervals (95%) calculated. Bootstrapping was used to confirm the estimated confidence intervals, and to generate acceptability curves representing the probability of the intervention being cost-effective at alternative monetary equivalent values for the outcomes avoiding high infant birth weight, and respiratory distress syndrome. Analyses utilised intention to treat principles. RESULTS: Overall, the increase in mean costs associated with providing the intervention was offset by savings associated with improved immediate neonatal outcomes, rendering the intervention cost neutral (Lifestyle Advice Group $11261.19±$14573.97 versus Standard Care Group $11306.70±$14562.02; p=0.094). Using a monetary value of $20,000 as a threshold value for avoiding an additional infant with birth weight above 4 kg, the probability that the antenatal intervention is cost-effective is 0.85, which increases to 0.95 when the threshold monetary value increases to$45,000. CONCLUSIONS: Providing an antenatal dietary and lifestyle intervention for pregnant women who are overweight or obese is not associated with increased costs or cost savings, but is associated with a high probability of cost effectiveness. Ongoing participant follow-up into childhood is required to determine the medium to long-term impact of the observed, short-term endpoints, to more accurately estimate the value of the intervention on risk of obesity, and associated costs and health outcomes. TRIALS REGISTRATION: Australian and New Zealand Clinical Trials Registry (ACTRN12607000161426).Jodie M Dodd, Sharmina Ahmed, Jonathan Karnon, Wendy Umberger, Andrea R Deussen, Thach Tran, Rosalie M Grivell, Caroline A Crowther, Deborah Turnbull, Andrew J McPhee, Gary Wittert, Julie A Owens, Jeffrey S Robinson and For the LIMIT Randomised Trial Grou

Early Atomic Models - From Mechanical to Quantum (1904-1913)

A complete history of early atomic models would fill volumes, but a reasonably coherent tale of the path from mechanical atoms to the quantum can be told by focusing on the relevant work of three great contributors to atomic physics, in the critically important years between 1904 and 1913: J. J. Thomson, Ernest Rutherford and Niels Bohr. We first examine the origins of Thomson's mechanical atomic models, from his ethereal vortex atoms in the early 1880's, to the myriad "corpuscular" atoms he proposed following the discovery of the electron in 1897. Beyond predictions for the periodicity of the elements, the application of Thomson's atoms to problems in scattering and absorption led to quantitative predictions that were confirmed by experiments with high-velocity electrons traversing thin sheets of metal. Still, the much more massive and energetic {\alpha}-particles being studied by Rutherford were better suited for exploring the interior of the atom, and careful measurements on the angular dependence of their scattering eventually allowed him to infer the existence of an atomic nucleus. Niels Bohr was particularly troubled by the radiative instability inherent to any mechanical atom, and succeeded in 1913 where others had failed in the prediction of emission spectra, by making two bold hypotheses that were in contradiction to the laws of classical physics, but necessary in order to account for experimental facts.Comment: 58 Pages + References, 8 Figures. Accepted for publication in the European Physical Journal H (Historical Perspectives on Contemporary Physics). V2 - minor typos corrected and a footnote added to p.2